Products : Legacy Products : UP1 Ultra Low Range Pressure Transducer

UP1 Ultra Low Range Pressure Transducer

UP1.
 

 

Features

  • Range 10"WG (25mbar/0.36psi)
  • Robust Housing
  • Standard Wheatstone Bridge Output
  • 700ohm bridge resistance
  • Differential or Gauge versions
  • Integral MIL-26482 Connector

The UP series pressure transducers are well proven and widely specified for monitoring pressure in process control systems, filter efficiency monitoring and pressure measurement.

When used in differential mode, the medium on the case side should be dry gas or non-conductive liquid. 

LCM Systems are able to offer the UP1 with a wide range of instrumentation products, to offer a complete system. Please contact our technical department to discuss your instrumentation requirements.

Specification

Range (FSO) ±10” W.G (±25 mbar or ±0.36 psi)
Maximum Overload Range 110% FSO
Maximum Port Line Pressure 100psi (with a differential pressure not exceeding 0.36psi)
Output Sensitivity 4mV/V nominally
Zero Offset < ±2% FSO
Accuracy < ±0.5% FSO
Repeatability < ±0.2% FSO
Excitation Voltage 10vdc maximum (5Vdc recommended)
Bridge Resistance 700Ω
Insulation Resistance > 100MΩ at 50vdc
Operating Temperature Range -30°C to +100°C
Compensated Temperature Range +10°C to +60°C
Zero Temperature Coefficient < ±0.05% FSO/°C
Span Temperature Coefficient < ±0.05% FSO/°C
Environmental Protection Level IP66
Connection Type Integral MIL-C-26482 Bayonet Lock Connector
Wiring Connections
Pin A Positive Signal
Pin B Positive Excitation
Pin C Negative Signal
Pin D Negative Excitation

Dimensions

up1 drawing

Downloads

Click here to download - UP1 Datasheet

Suggested Instrumentation

SGA Strain Gauge Analogue Amplifier

LCA15 Intelligent Strain Gauge Amplifier/Controller

TR150 Battery Powered Handheld Portable Indicator

ADW15 Panel Mounting Load Cell Indicator/Controller

Options

There are currently no options available to view from this page. To view the various options which may be available for the UP1, please view the UP1 product datasheet by clicking here.

Applications

  • Filter condition monitoring
  • Air flow simulation systems

Buy Now

Contact Us
Back to ListingPreviousNext

Copyright © 2017 LCM Systems
Unit 15, Newport Business Park, Barry Way, Newport Isle of Wight, PO30 5GY United Kingdom VAT no (GB 785 3956 71) and Co. Reg (2057541).

Powered By Intergage