LCM Systems Logo
     


                                              
 

Solutions in Load Cell Technology
   
Home Page Icon Home | Site Map Icon Site Map
Unit 15, Newport Business Park
Barry Way, Newport
Isle of Wight, PO30 5GY
United Kingdom
TEL: +44(0)1983 249264
FAX: +44(0)1983 249266

 

UP1 Ultra Low Range Pressure Transducer

UP1 Ultra Low Range Pressure Transducer
 
 

  • Features
  • Specification
  • Dimensions
  • Downloads
  • Suggested Instrumentation
  • Options
  • Applications
  • Range 10"WG (25mbar/0.36psi)
  • Robust Housing
  • Standard Wheatstone Bridge Output
  • 700ohm bridge resistance
  • Differential or Gauge versions
  • Integral MIL-26482 Connector

The UP series pressure transducers are well proven and widely specified for monitoring pressure in process control systems, filter efficiency monitoring and pressure measurement.

When used in differential mode, the medium on the case side should be dry gas or non-conductive liquid. 

LCM Systems are able to offer the UP1 with a wide range of instrumentation products, to offer a complete system. Please contact our technical department to discuss your instrumentation requirements.

Range (FSO) ±10” W.G (±25 mbar or ±0.36 psi)
Maximum Overload Range 110% FSO
Maximum Port Line Pressure 100psi (with a differential pressure not exceeding 0.36psi)
Output Sensitivity 4mV/V nominally
Zero Offset < ±2% FSO
Accuracy < ±0.5% FSO
Repeatability < ±0.2% FSO
Excitation Voltage 10vdc maximum (5Vdc recommended)
Bridge Resistance 700Ω
Insulation Resistance > 100MΩ at 50vdc
Operating Temperature Range -30°C to +100°C
Compensated Temperature Range +10°C to +60°C
Zero Temperature Coefficient < ±0.05% FSO/°C
Span Temperature Coefficient < ±0.05% FSO/°C
Environmental Protection Level IP66
Connection Type Integral MIL-C-26482 Bayonet Lock Connector
Wiring Connections
Pin A Positive Signal
Pin B Positive Excitation
Pin C Negative Signal
Pin D Negative Excitation
up1 drawing
There are currently no options available to view from this page. To view the various options which may be available for the UP1, please view the UP1 product datasheet by clicking here.
  • Filter condition monitoring
  • Air flow simulation systems 

Powered By Intergage | Content Management System