WAS Force Washer Through Hole Load Cell |
|
|
|
- Features
- Specification
- Dimensions
- Downloads
- Suggested Instrumentation
- Options
- Applications
- Ranges 12.5kN to 540kN
- Stainless Steel Construction
- Environmentally sealed to IP66
- Special Sizes and ranges available
- Higher Accuracy versions available
- Many other variants may be available (please contact technical support with any requirements you may have)
The WAS range of load cells from LCM Systems have been specifically designed for applications where there is a requirement for the force application component to pass through the centre of the load cell. This style of product is often referred to by different names, including annular load cells, force washers, donut load cells, through hole load cells etc.
The main application for the WAS series is measuring the tension in bolts for safety monitoring and control, or general quality control. LCM Systems specialise in the design of custom load cells, so have also been heavily involved in designing similar product for rock anchor force measurement, fork lift truck weighing, and tie rod tension monitoring.
If you have a requirement for an annular or through-hole load cell that can not be satisfied with the standard WAS series, then contact our technical department with your requirement, and we will probably be able to solve your application problem for you.
The WAS series can be supplied as a stand alone product or be incorporated into an instrumentation package, to meet your specific application requirements.
|
| Range |
(FSO) 12.5, 25, 35, 50, 100, 160, 200, 250, 300, 360, 540kN |
| Maximum Overload Range |
150% FSO |
| Output Sensitivity |
1.5mV/V nominal |
| Zero Offset |
< ±5% FSO |
| Linearity |
< ±1.5% FSO (between 50% and 100% FSO) |
| Repeatability |
< ±1% (if mounting position remains unchanged) |
| Excitation Voltage |
10vdc recommended, 15vdc maximum |
| Bridge Resistance |
700Ω |
| Insulation Resistance |
> 500MΩ at 100vdc |
| Operating Temperature Range |
-20°C to +70°C |
| Compensated Temperature Range |
+10°C to +60°C |
| Zero Temperature Coefficient |
< ±0.03% FSO/°C (< ±0.01% FSO/°C optional) |
| Span Temperature Coefficient |
< ±0.03% FSO/°C (< ±0.01% FSO/°C optional) |
| Environmental Protection Level |
IP66 |
| Connection Type |
PVC 4-core cable, exiting via cable gland,
2 meters long |
|
| There are currently no options available to view from this page. To view the various options which may be available for the WAS, please view the WAS product datasheet by clicking here. |
- Bolt tension monitoring
- Fork Lift Truck Overload Protection
- Failsafe Cable Tension monitoring
- Press Tool force measurement
|
|
|
|
|
|
